|In your basket: 0 pcs in total 0 €|
The historical belt is made of up to 4 mm thick smooth cowhide. The belt's length is 150 cm. If you pay a certain additional fee we will produce for you a longer belt to order. The belt's maximum production length is 210 cm. The belt's width is 4 cm. The belt is provided with hand-hammered wrought buckle that was modelled on a specimen from circa the 10th -11th century. The leather belt is connected to the wrought buckle with a leather strip. Along its entire edge the belt is decorated with an engraved groove.
Advice for the wearer of the leather belt with a twisted wrought buckle: If you untangle the leather strip you can replace the buckle with any buckle of the same width. Please specify your waist measure in your order. Based on this information we will cut holes in your belt to secure that it fits well. Otherwise the first hole is cut out at the length corresponding to the waist measure of 90 cm.
Please note: This product is made by hand from genuine leather. This is a purely natural material. Minor differences in the colour and surface texture are its natural characteristics. These small imperfections do not decrease the value of the product. Each piece is to some extent an original.
The daggers are approximately made as follows. The basic shape of the blade is made by a laser CNC machine. It is burned from spring steel. The semi-finished blade follows then in the groove cutter, where the cutting edge and the groove are milled. The blade is then oil-quenched and tempered to the desired hardness. Then the guard and pommel is attached to the blade tang. The tang is usually peened at the end (behind the pommel) and the cross-guard hard soldered with brass. Hardwood plates are placed under the handle wrapping from genuine cowhide so that the handle is sufficiently robust for a safe grasp. The steels surfaces obtain the desired finish in the end - with a wire brush or with a felt disc with polishing paste.