|In your basket: 0 pcs in total 0 €|
This type of suspended scabbard is inspired by the model of the scabbard used by the great Scottish hero W. Wallace. The hanger was designed in detail according to the hero W.W. featured in the film Braveheart. The scabbard is made of up to 3 mm thick smooth cowhide, the hanger is made of up to 4 mm thick smooth cowhide. It is worn across the back via a wide carrying strap.
We will make a made-to-measure scabbard for you corresponding to the size of a falchion or sabre that was ordered with this scabbard. If you are ordering the scabbard alone, please send us an outline of the falchion blade. You can also send us your falchion or scabbards, so that we may double check that it fits perfectly bere despatch. The baldric itself may be made to measure. If the standard size does not suit you (sports figure XL with the height of about 175cm), send us a slanted circumference of your trunk copying the position of the baldric as shown in the photo on this page.
Please select the shoulder over which the sword should stick out. Our model is a right-hander and therefore the falchion sticks out over his right shoulder. A hand-forged buckle is located on the front strap of the baldric so that you can adjust its size when needed.
Warning: This baldric with the scabbard is designed for transport of long flachions and not for the unsheathing of the falchion at short notice because the blade is too long to be pulled out easily.
Please note: This product is made by hand from genuine leather. This is a purely natural material. Minor differences in the colour and surface texture are its natural characteristics. These small imperfections do not decrease the value of the product. Each piece is to some extent an original.
The daggers are approximately made as follows. The basic shape of the blade is made by a laser CNC machine. It is burned from spring steel. The semi-finished blade follows then in the groove cutter, where the cutting edge and the groove are milled. The blade is then oil-quenched and tempered to the desired hardness. Then the guard and pommel is attached to the blade tang. The tang is usually peened at the end (behind the pommel) and the cross-guard hard soldered with brass. Hardwood plates are placed under the handle wrapping from genuine cowhide so that the handle is sufficiently robust for a safe grasp. The steels surfaces obtain the desired finish in the end - with a wire brush or with a felt disc with polishing paste.